Note on reassembling:
• When assembling the "SA, Fan", pass the cable
between the boss and the frame as shown on the right.
(Wind the cable on the boss counterclockwise.)
3-6-5. Ribbon Gears
1. Open the "Cover Top" Block and remove the "Unit, Ribbon". Refer to
2. Remove the ribbon covers. Refer to
3. On the front side, remove the 1 screw (No.0PH (4-0.3)M2x3 (NI)) () and "Plate Ribbon
Washer". Then, remove the "SA, Holder R Shaft", "Spring Ribbon Shaft", "Spring Ribbon
Return" and "Gear Ribbon Shaft F" in that order.
4. Also on the front side, disengage the "Polyslider, Knob-2" and remove the "Gear Reduction
Ribbon 2" (), "Gear Reduction Ribbon 1" (), "Gear Reduction Ribbon 3" (), and "Gear
Idle Ribbon" () in that order.
5. On the rear side, remove the 1 screw (No.0PH (4-0.3)M2x3 (NI)) () and "Plate Ribbon
Washer". Then, remove the "SA, Holder R Shaft", "Spring Ribbon Shaft", "Spring Ribbon
Return" and "Gear Ribbon Shaft R" in that order.
6. Also on the rear side, disengage the "Polyslider, Knob-2" and remove the "Gear Reduction
Ribbon 2" (), "Gear Reduction Ribbon 1" (), "Gear Reduction Ribbon 3" (), and "Gear
Idle Ribbon" () in that order.
[Magnified View]
Gear Reduction Ribbon 3
Polyslider, Knob-02
Gear Reduction Ribbon 2
"3-6-4(1) Removing the ribbon
FLOIL G-474C
Gear Ribbon Shaft F
Spring Ribbon Return
Gear Reduction
Ribbon 1
Gear Idle Ribbon
Disassembly, Reassembly and Lubrication
Gear Ribbon Shaft R
8
9
Gear Reduction Ribbon 1
Gear Reduction Ribbon 3
7
Gear Reduction Ribbon 2
Polyslider, Knob-02
Spring Ribbon Shaft
SA, Holder R Shaft
Plate Ribbon Washer
No.0PH (4-0.3)M2x3 (NI)
3-19
J106
"3-6-2 Unit,
Ribbon".
covers".
Spring Ribbon Return
Spring Ribbon Shaft
SA, Holder R Shaft
Plate Ribbon Washer
No.0PH (4-0.3)M2x3 (NI)
10
Gear Idle Ribbon
oss
CL-S6621