Table of Contents
Advertisement
Disassembly, Reassembly and Lubrication
3-6-1. "Cover Top" and "Support Top Cover"
(1) Removing the "Cover Top" Block
1. Before starting, remove the "SA, Ribbon Holder" (2 pcs.) from the printer.
2. Open the "Cover Top" Block half way as shown in the figure. (Do not fully open it.)
3. Insert a flat-blade screwdriver into the right side corner of the "Cover Top" Block as shown,
then push the
Top" Block come off the main body.)
Then, remove the "Cover Top" Block. (At this moment, a sound may be heard to some
degree.)
Note on reassembling:
• First, with the opening angle of the "Cover Top" Block set as shown, insert the protrusion "B"
on the left side of the "Cover Top" Block into the hole in the main body.
Next, align the protrusion "C" with the hole
again with the flat-bladed screwdriver, insert the right side corner of the "Cover Top" Block
into the main body.
CL-S6621
"Plate
A" outward with the screwdriver end. (The projections of the "Cover
"Cover Top" Block
ibbon Holders
late A
"C'
", and, while pushing the
C'
3-10
late A
"Plate
A" outward
Plate A
C
Advertisement
Chapters
Table of Contents
