Table of Contents
Advertisement
Disassembly, Reassembly and Lubrication
2. Remove the 2 screws (PH, M3x10) ( and ) and 2 screws (BH, M3x4 (NI)) (). Then,
remove the "Plate Holder Head" Block () in the direction of arrow.
3. Remove the "Spring Head L", "Spring Head R" (2 pcs.), "Plate Head Balance" and "Spacer
Head Balance".
4. Remove the 1 screw (PH, M3x6) () and detach the "Pivot Head Balance Cam" and "Cam
Head Balance".
5. Remove the 1 screw (BH, M3x4 (NI)) and detach the "Holder Guide Sensor U".
6. Remove the 1 screw (BH, M3x4 (NI)) and detach the "Plate Ribbon Cable Stay".
7. Remove the ""Support Pop Up" and peel off the labels ("Label 2, Caution Head (AH50)",
"Label 6, Caution, Head/Label 7, Caution, Head/Label, Caution Head (China)" "Label, Head
Adjust" and "Label, Head Balance") from the "SA Cover Frame".
Spring Head L
Plate Head Balance
BH, M3x4 (NI)
Plate Ribbon
Cable Stay
SA Cover Frame
PH, M3x10
Notes on reassembling:
• Apply FLOIL G-311S to the following places. (See the mark
Pivot Head Balance Cam: Surface.
Cam Head Balance: Along the cam surface.
SA Cover Frame: The slit into which the claw of "Plate Head Balance" is inserted.
(to be continued on the next page)
CL-S6621
BH, M3x4 (NI)
PH, M3x10
Spring
Head R
Support Pop Up
Label, Head Adjut
Label, Head Balance
3-44
"Plate Holder Head" Block
Label 2, Caution, Head (AH50)
Label 6, Caution, Head/
Label 7, Caution, Head/
Label, Caution Head
Spacer Head Balance
PH, M3x6
Pivot Head Balance Cam
Holder Guide Sensor U
BH, M3x4 (NI)
shown in the figure.)
Cam Head Balance
FLOIL G-311S
Advertisement
Chapters
Table of Contents
