Disassembly, Reassembly and Lubrication
7. Remove the "Carriage Adjust Sensor L" and other related parts.
1) Remove the 1 screw (BH, M3x4 (NI)) (), and detach the "Cover Sensor Cable L".
2) Remove the 2 screws (BHT (PT), M2x6) () and detach the "Carriage Adjust Sensor
L".
3) Remove the "Pinion Sensor L" and "Leaf Pinion Sensor L" from the "Carriage Adjust
Sensor L".
4) Disengage the "E-Ring 3" (), remove the "Wave Washer 4x8xt0.15" and "Spacer, CR
Shaft", and then detach the "Shaft Lead Screw".
5) Remove the 1 screw (BH, M3x4 (NI)) () and detach the "Holder Screw L" and "Gear
Lead Screw L".
6) Remove the "Sheet Blind" from the frame.
8. Remove the "SA, Head Up Switch".
1) Remove the 1 screw (BH, M3x4 (NI)) () and detach the "Guide Cover Frame Pop Up"
Block. Then, remove the "Spring Pop Up" and "Pop Up Cover Frame" from the "Guide
Cover Frame Pop Up".
2) Remove the 1 screw (No.0, PHT (BT #3), M1.7x7) () and detach the "SA, Head Up
Switch".
FLOIL G-311S
Gear Lead Screw L
Holder Screw L
Shaft Lead Screw
Carriage Adjust Sensor L
BHT (PT), M2x6
Cover Sensor Cable L
CL-S6621
Wire Tie
a
b
c
a
d
b
c
Pinion Sensor L
d
Leaf Pinion Sensor L
a
Wire Tie
Sheet Blind
Spacer, CR Shaft
Wave Washer
4x8xt0.15
E-Ring 3
BH, M3x4 (NI)
No.0, PHT (BT #3), M1.7x7
SA, Head Up Switch
BH, M3x4 (NI)
3-48
BH, M3x4 (NI)
Guide Cover
Frame Pop Up
Pop Up Cover Frame
Spring Pop Up