Gears - Citizen CL-S6621 Technical Manual

• After assembling the "Holder, Guide
Sensor L", push the "Spacer Guide
Shaft" toward the right side frame as
shown on the right.
• After assembling each part, arrange the
wires. (Refer to the "Notes on
reassembling" in above
"Carriage Adjust Sensor L" and "SA, Head
Up Switch"".)

3-6-21. Gears

1. Remove the "Unit, Mechanism". Refer to
2. Remove the 1 screw (PH (PW), M2x8), and detach the "Support PF Idle Gear".
3. Remove the "Washer, Platen" and pull out the "Gear Reduction PF2. Then, pull out the "Gear
Reduction PF1" and "Gear Idle PF".
4. Remove the 2 screws (PH, M3x6) and remove the "Hinge One Way" Block.
5. Disengage the "E-Ring 4" and remove the "Gear One Way Hinge" and "Shaft One Way Hinge"
from the "Hinge One Way".
PH (PW), M2x8
FLOIL G-311S
Gear Idle PF
Gear Reduction PF 1
Gear One Way Hinge
Shaft One Way Hinge
Hinge One Way
PH, M3x6
[When assembling]
Note on reassembling:
• Apply FLOIL G-311S to each gear shaft (3 shafts) and to each gear surface. (See the mark
shown in the figure.)
Spacer Guide Shaft
"3-6-20(1)
"3-6-13(1) Unit,
Support PF Idle Gear
Washer, Platen
Gear Reduction PF 2
c
b
a
E-Ring 4
D-cut
Disassembly, Reassembly and Lubrication
Mechanism".
3-51
Holder, Guide Sensor L
c
b
a
CL-S6621