Table of Contents
Advertisement
Disassembly, Reassembly and Lubrication
2. Remove the "Spring Head Holder" () from the "SA Head Adjust Lever" Block.
3. In the "SA Head Adjust Lever" Block, disengage the 3 E-rings (E-Ring 3) () to detach the
"SA Head Adjust Lever" from the "Base Head Adjust" Block.
4. Remove the 1 screw (PHT (#2), M2x6) (), and detach the 1 washer (Plain, 2.6x6.5x0.5)
and "Spring, Adjust Cam". Next, pull out the "Bush Head Adjust" from the "Guide, Head
Adjust (Spring)" and detach the "Guide, Head Adjust (Spring)" and "Cam Head Adjust" from
the "Base Head Adjust".
5. Pull out the "Bushing Head" (2 pcs.), and then remove the 1 screw (BH, M3x4 (NI)) and
detach the "Plate Head Earth" from the "Plate Holder Head".
Spring Head Holder
Bushing Head
Plate Holder Head
(On the pposite side)
FLOIL G-311S
Notes on reassembling:
• Apply FLOIL G-311S to the following places. (See the mark
Plate Holder Head: Surface where the "Spring Head Holder" () contacts and its opposite
Base Head Adjust: Holes (5 pcs.) and 1 groove.
• When assembling the "Spring Head Holder":
Assemble the "Spring Head Holder" ("D") on the "SA Head Adjust Lever" Block as shown in
the magnified view. Then, insert them into the "Plate Holder Head" Block as shown.
Spring Head Holder
"SA Head Adjust Lever" Block
CL-S6621
Base Head Adjust
SA Head Adjust Lever
BH, M3x4 (NI)
side.
"Plate Holder Head" Block
D
E-Ring 3
Spring, Adjust Cam
Plate Head Earth
Bushing Head
3-46
PHT (#2), M2x6
Plain, 2.6x6.5x0.5
Bush Head Adjust
Cam Head Adjust
Guide, Head Adjust (Spring)
a
shown in the figure.)
"Plate Holder Head" Block
b
Advertisement
Chapters
Table of Contents
