8. Move the end "A" of the "Spring Guide Paper U" from "a" to
9. Disengage the "E-Ring, 2.5" () and pull out the "Shaft Hinge Guide Paper U" (), and then
remove the "Wave Washer 4x8xt0.15", "Polyslider", "Spring Guide Paper U", "Spacer Hinge
Shaft" and "Gear Bevel Idle Sensor U".
10. Remove the 5 screws (BHT (PT), M2x6) () and detach the "Cover Guide Paper U".
11. Disengage the "E-Ring 3" (), remove the "Spacer, CR Shaft", and pull out the "Shaft Lead
Screw" from the "Gear Bevel Lead Screw U" and "Guide Paper U" Block.
12. Remove the 3 nuts ((#3), M2) () with a nut driver and detach the "Pin Guide Paper U" (3
pcs.), and then remove the "Leaf Holder Adjust Sensor U" from the "Guide Paper U".
E-Ring, 2.5
Guide Paper L
Gear Bevel Idle
Sensor U
Spring Guide Paper U
Spacer Hinge Shaft
Gear Bevel Lead Screw U
FLOIL G-311S
a'
a
A
A
Shaft Hinge Guide Paper U
Wave Washer
4x8xt0.15
Polyslider
Nut, (#3), M2
Pin Guide Paper U
3-39
Disassembly, Reassembly and Lubrication
"a'
" to set the end free.
BHT (PT), M2x6
Cover Guide Paper U
Leaf Holder Adjust Sensor U
BHT (PT), M2x6
Shaft Lead Screw
Spacer, CR Shaft
E-Ring 3
Guide Paper U
CL-S6621