General Specifications - Citizen CL-S6621 Technical Manual

1-1.

General Specifications

Printing
Printing method
Resolution
Max. print width
Max. print length
Print density
Printing speed setting
Print mode
Batch mode
Tear off mode
1
Cut mode *
1
Peel mode*
Media
Types of media
Recommended media Thermal transfer: label media (LR1111 Lintec)
Max. media width
Min. media width
Min. label width
2
Min. label pitch*
Max. media thickness
Max. media length
Min. media length
Min. media thickness
On-board roll media
diameter
*1: Options can be separately purchased.
*2: When a media pitch of less than 1" is used, set the "Small Media Adjustment" setting in the
"Page Setup" menu to "On".
Thermal transfer/Direct thermal
Main scanning line density: 203 dots/inch (8 dots/mm)
Sub-scanning line density: 203 dots/inch (8 dots/mm)
Head 1344 dots (effective dots: 1344 dots)
168 mm
2539.7 mm
Print density is adjustable with software
6, 5, 4, 3 or 2 inches per second
Normal printing (single or multiple sheets)
Feeds back media to the tear-off position after printing is completed.
Prints while cutting at designated sheet units.
The following two kinds of cut mode operations are available.
• Back feed
• Cut through
(Cut through refers to stopping present printing to cut the previous
label when it reaches the cut position. After cutting, printing restarts
but a gap may be created at the seam of the printing at this time.)
Peels labels from the liners after printing them.
Roll, fanfold
(continuous media, die-cuts, continuous tags, paper or tickets)
Direct thermal media: label media (150LA-1 Ricoh),
178.0 mm
50.0 mm
50.0 mm
19.0 mm
0.254 mm
2539.7 mm
16.0 mm
0.0635 mm
Max. external diameter: 127mm
Media core: 25.4 to 76mm
Min. media core external diameter
(when using label media): 50.8 mm
1-3
6.6inch
99.99 inch
tag media (130LHB Ricoh)
7.01"
1.97"
1.97"
0.748"
0.01"
99.99"
0.63"
0.0025"
5"
1 to 3"
2"
General Specifications
CL-S6621