Notes on reassembling:
• When the "SA, Main PCB" is replaced with new one, perform the sensor adjustment. Refer to
"3-7-1 Transparent/Reflective Sensor Position
• When running the "Cable, Opepane", pass it inner side of the case arms "A". Also, after running
the "Cable, Opepane", stick it to the case frame at point "B" with a double-faced tape.
Cable, Opepane
• When connecting the flexible cable, be sure that the insertion direction is correct. If you insert it
reversely, circuit is not electrically connected.
•
For the "Cable, Opepane" connected to the connector (J4), face its foil side to the rear of the
printer.
•
For the cable (J9), face up its foil side.
J12
(J10) (J13)
J8
J9
J11
J7
(J14)
J6
J4
J19
A
B
(Foil side)
J9
(Blue tape side)
J5
To SA TRA Sen PCB
J4
(Foil
(Blue tape
side)
side)
J3
To SA, Opepane PCB
Disassembly, Reassembly and Lubrication
Adjustment.
J4
3-29
CL-S6621