Table of Contents
Advertisement
Disassembly, Reassembly and Lubrication
Notes on reassembling:
• Apply FLOIL G-311S to the groove of the "Shaft Lead Screw" shown by the
• When assembling the "Spring Guide Paper U",
follow the next steps.
1) First, hook the end "B" as shown below.
2) Next, insert the end "A" into the opening "a"
and move it from "a" to
the opening
"a'
• When assembling the "FFC, TRA Sensor", run it as shown below.
• When assembling the "Holder Adjust Sensor U", assemble it so that its projection "A" is inserted
into the groove end
Sensor U" with the "Guide Paper U" by aligning the projected parts "B" and
Shaft Lead Screw
Groove end
• When the "SA TRA Sen PCB" is replaced with new one, perform the sensor adjustment. Refer to
"3-7-1 Transparent/Reflective Sensor Position
CL-S6621
"a'
" to hook it on
" as shown below.
FFC, TRA Sensor
"A'
"of the "Shaft Lead Screw". Also, securely engage the "Holder Adjust
Projection "
B'
"A'
"
Guide Paper U
Spring Guide Paper U
Holder Adjust Sensor U
A
"
B
Holder Adjust Sensor U
Adjustment.
3-40
mark.
a'
A
B
A
B
"B'
".
a
Advertisement
Chapters
Table of Contents
