Part Names - Pioneer PDP-V401 Technical Manual

Part names

2.3 Part names
<Terminals and power supply section>
8 9 0
7
VD
(Ω)
OFF ON 75 2.2k
RGB-2
G ON SYNC SYNC
<Operation panel>
1 STANDBY/ON indicator
The switch lights in RED for STANDBY and GREEN for
ON mode.
2 Power button
Turns power on or off.
3 INPUT select button
Selects input.
4 MENU button
Used to switch the menu screen and normal screen.
5 ADJUST button
Used for picture adjustment.
6 SET button
Used to select a selected adjustment item during
picture adjustment.
<Terminals and power supply section>
RGB-2 input terminals
7 Mini D-SUB15 pin terminal
8 G-on SYNC mode select switch (ON/OFF)
If pictures take on a greenish cast when other
external equipment is connected to the RGB-2 input
terminal, turn on the G-on SYNC mode. Normally,
this switch is left off.
RGB-1 input terminals
9 Synchronizing signal input impedance select switch
(75 Ω /2.2 kΩ)
8
<Ver. 2.1>
(The terminals and power supply section are located at the back of the plasma display main body.)
- = ~ ! @
HD B G R C
(H/V SYNC) RGB-1 (ON SYNC)
<Operation Panel>
STANDBY
/ON
1
2
˚ (
INPUT
3
MENU
4
ADJUST
5
SET
6
# $ % ^
Y OUT IN
Y/C VIDEO RS-232C
0 Vertical synchronizing signal input terminal:
Switching between 75 Ω /2.2 kΩ)
- Horizontal or composite synchronizing signal input
terminal: Switching between 75 Ω /2.2 kΩ
= Blue signal input terminal: 75 Ω
~ Green signal or synchronizing (ON SYNC) green
signal input terminal: 75 Ω
! Red signal input terminal: 75 Ω
Y/C input terminal
@ Color signal input terminal: 75 Ω
# Luminance signal input terminal: 75 Ω
VIDEO input/output terminal
$ Video output terminal: 75 Ω
(Note: Up to four units including the unit to which
the signal is first input may be connected when the
equipment is connected in series using this output
terminal. However, increasing the number of
connected units may increase noise.)
% Video input terminal: 75 Ω
^ Control signal input terminal (RS232C)
& AC INLET
* Main power switch
( KEY LOCK/UNLOCK button (hidden switch)
Use this button to disable or enable control through
the operation panel or by remote control.
& *