Pioneer PDP-V401 Technical Manual page 86

Plasma display
Hide thumbs Also See for PDP-V401:
Table of Contents

Advertisement

Mounting standard metal fixtures (PDK-4006)
3. After securing the fixture with screws, open it as shown in the figure and tighten the screws c on the left and
right sides of the vertical frame.
5) Mounting the plasma display
1. As shown below, two workers should hold the left and right ends of the plasma display and insert four monitor
fixing bolts into the mounting fixture holes. First insert the bolts in the bottom holes, then in the top holes.
2. The display mounting is complete. Now set the optimal angle.
86
<Ver. 2.1>
c
Display
Wall side
Insert a monitor fixing
bolt into the hole of the
mounting fixture and
set it down.
Tighten the screw from
above to prevent the bolt
from falling out.
Tighten the nut.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents