Pioneer PDP-V401 Technical Manual page 78

Mounting standard metal fixtures (PDK-4005)
2) Assembly procedure
1. Temporarily tighten the vertical frame (1) and the horizontal frame (2) by using the M5 plus/minus screw (5) and
the M5 wave washer (4).
When assembling the PDP bracket, install an M8 nut, as shown, to keep the Special eye bolt from loosening.
(This step is not described in the instruction manual.)
3
7
Four M8 nuts
* Secure the nut as close to the
root of the bolt as possible.
Before screwing together the horizontal frame and
vertical frame, place the frames on a flat surface, as
shown, and confirm that the holes match up correctly.
Caution
<Incorrect>
Table or similar flat surface
When the frames are placed on a flat surface
as above, inserting bolts into the holes is
difficult.
78
<Ver. 2.1>
3
1
4
5
4
5
3
4
1. Install the Special eye bolt to the main body
of the plasma display, along with the M8 nut.
1
4
3
2
4
4
3
2
2. Tighten the nut with a spanner.
5
5