Precautions - Pioneer PDP-V401 Technical Manual

Performing adjustments on the plasma display operation panel
14) Initial reset setting mode (total adjustment)
This function restores adjusted values for PICTURE PARAMETER and WHITE BALANCE to factory-preset values,
which are within the range of values currently held in the selected memory area. Selecting "YES" with the remote
control 2 button or operation panel + button restores factory-preset values. Selecting "NO" with the remote control 3
button or operation panel – button restores the current state. Select the following:
"YES" to restore factory-preset values
"NO" to avoid restoring factory-preset values
and press the SET button.
In either case, you are returned to the above adjustment mode when selection is complete.

5.2.3 Precautions

• Input cannot be switched over in Menu or Integrator modes.
First select the input to adjust, then move to Menu mode or Integrator mode.
• The system automatically exits Menu mode or Integrator mode if one of the following occurs:
a) The main switch is turned off (AC OFF).
b) STANDBY status is invoked.
c) A non-operational period persists for approx. 180 seconds.
d) The KEY-LOCK button of the main body is pressed.
e) Input signals are externally switched-over, or a no-signal state arises.
f) The system is switched to RS232C adjustment mode with an <AJY> command.
g) The protective circuit (P.D.) is activated.
Note: For a) and g), only the item currently being adjusted is not placed in latest data in the memory.
P A R A M E T E R
P I C T U R E
W H I T E B A L A
D I O
A D I T N A
T O T A L I N I
I N I T I A L I Z E ?
Y E S
N C E
L
S E T U P
T I A L I Z E
N O
and remote control
<Ver. 2.1>
125