Download  Print this page

Advertisement

Mounting standard metal fixtures (PDA-4001 • PDA-4002)
5. Assembling the filter
Install the filter assembled in Step 4, hanging it on the
metal fixture from the top of the plasma display.
Set the bottom of the filter outside the metal fixture
and attach with the decorative screws.
Always install from above the filter.
2
3
5
D
5
6. The metal fixture installed (as seen from the back of
the plasma display)
2, 3
1
94
<Ver. 2.1>
2
3
2, 3
1
7. With the filter installed (front)
When all assembly work is complete, peel off the
protective film on the front of the filter.
D
8. Maintenance
The filter surface is delicate, due to its special anti-
glare coating. To clean the filter surface, brush dust
from the surface and wipe with a soft cloth. Do not
use hard or abrasive materials, such as tissue paper.
Use of solvents such as benzene or thinner will damage
and discolor the filter coating.
If the inside of the filter becomes dirty, unscrew
the decorative screws and remove the filter. In this
case, unscrew the bottom screws first.
Handling the filter carefully, clean the inside surface in
the same way as for the outer surface.
Install the filter by reversing the above procedures,
beginning by first tightening the decorative screws
on the top. Make sure the screws are adequately
tightened.

Advertisement

Table of Contents

   Related Manuals for Pioneer PDP-V401

Comments to this Manuals

Symbols: 0
Latest comments: