Assembling And Installing The Metal Fixture And Mounting The Plasma Display - Pioneer PDP-V401 Technical Manual

4.4.2 Assembling and installing the metal fixture and mounting the plasma display

7 Procedure for assembling the fixture
1. Insert the round joint into each end of the joint pipe.
2. Temporarily attach one joint pipe to the stand frame L or R using an M8 × 60 hexagon socket button head screw and
washer.
3. Temporarily attach the other stand frame to the other joint pipe.
Washer
Hexagon socket button
head screw M8 × 60
Washer
Round joint
4. With the screen of the plasma display facing downwards, place the display on the edge of a horizontal and stable
table as indicated in the following figure. Be sure not to drop or damage the unit.
5. Fix the stand frames to the plasma display by tightening 6 M8 × 45 hexagon socket button head screws and washers.
6. Place the stand frames on a flat surface, and tighten the set screws to the joint pipes.
Hexagon socket button
head screw M8 × 45
Plasma display
Mounting standard metal fixtures (PDK-4001)
Stand frame L
Round joint
Joint pipe
Joint pipe
Round joint
Washer
Table
Stand frame R
Round joint
Washer
Hexagon socket button
head screw M8 × 60
Washer
61
<Ver. 2.1>