Sun Microsystems SPARC classic Service Manual page 10

System I/O Board and Unit Bottom 8-8
FIGURE 8-3
Extracting the Main Logic Board 8-10
FIGURE 8-4
Raising the Speaker/LED Assembly 8-10
FIGURE 8-5
Removing and Replacing the Main Logic Board 8-11
FIGURE 8-6
Removing the System I/O Board 8-12
FIGURE 8-7
Plugging in the Main Logic Board 8-14
FIGURE 8-8
Hard Disk Drive in the Disk Drive Bracket 9-3
FIGURE 9-1
Jumper Settings for 207-Mbyte Drive With Jumpers on the Left-Hand Side 9-4
FIGURE 9-2
Jumper Settings for 207-Mbyte Drive With Jumpers on the Right-Hand Side 9-5
FIGURE 9-3
Jumper Settings for 424-Mbyte Drive 9-6
FIGURE 9-4
Jumper Settings for Conner 535-Mbyte Drive 9-7
FIGURE 9-5
Jumper Settings for Seagate 535-Mbyte Drive 9-8
FIGURE 9-6
Jumper Settings for 1.0-Gbyte Drive (Part 370-1546) 9-10
FIGURE 9-7
Jumper Settings for Seagate 1.0-Gbyte Drive 9-11
FIGURE 9-8
Jumper Settings for Connor 1.0-Gbyte Drive 9-12
FIGURE 9-9
Installing a Hard Disk Drive 9-14
FIGURE 9-10
Main Logic Board 9-15
FIGURE 9-11
Open View of System Unit 9-17
FIGURE 9-12
Removing the Disk Drive Mounting Bracket 9-18
FIGURE 9-13
Detail of Disk Drive Mounting Bracket 9-19
FIGURE 9-14
Replacing the Disk Drive Mounting Bracket 9-20
FIGURE 9-15
Disk Drive Mounting Bracket 9-22
FIGURE 9-16
Main Logic Board Layout—SPARCclassic/SPARCclassic X Systems 10-4
FIGURE 10-1
Main Logic Board Layout—SPARCstation LX System (Part 270-2233) 10-5
FIGURE 10-2
Main Logic Board Layout—SPARCstation LX System (Part 270-2474) 10-6
FIGURE 10-3
View of Open System Unit 10-8
FIGURE 10-4
Removing the SBus Card 11-3
FIGURE 11-1
SBus Slot Filler Panels 11-3
FIGURE 11-2
x SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual • November 1993