Figure 11-19 Locating The Nvram; Figure 11-20 Removing The Nvram - Sun Microsystems SPARC classic Service Manual

under these conditions. Disconnect the AC power cord prior to handling the power
supply. When servicing any other system component, the AC power cord should
remain connected and poses no safety hazard.
2. Locate the NVRAM chip carrier on the main logic board.
See
FIGURE 11-19
3. Hold the NVRAM chip carrier on both ends, and lift the chip straight up.
Gently wiggle the carrier as necessary (see
4. Place it on the antistatic mat.
FIGURE 11-19
FIGURE 11-20
11-32 SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual • November 1993
.
Locating the NVRAM
Removing the NVRAM
).
FIGURE 11-20