Toner Collection Coil And Toner Recycling Belt Replacement - Ricoh A219 Service Manual

AROUND THE DRUM
3.5 TONER COLLECTION COIL AND TONER RECYCLING
BELT REPLACEMENT
[H]
[E]
1. Open the front cover.
2. Remove the imaging unit. (See Imaging Unit Removal.)
3. Cut the seal [A] as shown.
4. Remove the toner recycling cover [B] (2 screws).
5. Remove the bearings [C,D].
6. Remove the toner recycling belt [E].
7. Remove the toner collection coil [F].
NOTE: When removing the toner collection coil, do not lose the rear gear
[G].
8. Replace the toner recycling belt and toner collection coil.
NOTE: When installing a new toner recycling belt, make sure that the
belt [H] is properly positioned, as shown.
When reinstalling the toner recycling cover, make sure that there
is no gap between the toner recycle cover and the imaging unit
cover.
A219
CÓPIA NÃO CONTROLADA
[B]
[F]
A219R522.wmf
6-22
CÓPIA NÃO CONTROLADA
[D]
A219R558.wmf
[E]
[C]
[A]
SM