Ricoh A219 Service Manual page 142

Mode No.
Total Copy Displays the total (electrical) copy counter.
Counter
The first three digits are displayed in the
Display
magnification indicator.
Press the
88
The mechanical total counter and the electrical
total counter may not always display the same
value, because of initial differences in the
counter values.
Factory Data Factory use only.
90 and Counter
Clear
V Correction Resets the drum residual voltage correction counter
R
*
Reset for the VR correction.
93 To clear, enter "1" then press the
Use this mode only after installing a new drum.
V Correction Resets the exposure lamp data and counter for the
L2
Reset V
L2
*
as a set.
94 To Clear, enter "1" then press the
Normally not needed in the field, as this is handled
by SP48.
V Correction Resets the exposure lamp data and counter for the
L
Reset V correction. Always perform this mode with SP94
L
*
as a set.
95
To clear, enter "1" then press the
Normally not needed in the field, as this is handled
by SP48.
Toner End The Toner End condition is canceled forcibly.
96 Force Cancel
By pressing the
toner end condition is canceled.
Service Call Resets a service call (E5) condition.
97 (E5) Reset
Turn the main switch off and on to check if the
service call condition is reset.
Total Counter Clears the total (electrical) counter.
Clear Normally, this SP mode should not be
performed.
*
To clear, enter "1" then press the
98
To avoid resetting the counter by mistake, the
counter is reset only when the
key are pressed at the same time.
SM
CÓPIA NÃO CONTROLADA
Function
*
key to view the last three digits.
key at the same time.
correction. Always perform this mode with SP95
key at the same time.
key at the same time.
key to enter this SP mode, the
key at the same time.
4-21
CÓPIA NÃO CONTROLADA
PROGRAM MODES
Settings
0: No
1: Yes
key and the
0: No
1: Yes
key and the
0: No
1: Yes
key and the
0: No
1: Yes
key and the
*
key and the
A219