Ricoh A219 Service Manual page 140

Mode No.
Optics Displays the optics temperature detected by the
Temperature optics thermistor.
59
Display
Press the
during the normal copy cycle.
Drum Potential Factory use only.
60 Measurement
(With Paper)
Drum Potential Factory use only.
Measurement
61
(Without
Paper)
V Correction Sets the interval for V
L
Interval lamp voltage (SP48) is increased by 1 step at the
set copy count interval.
SP Setting
62
1 step of the lamp voltage equals 0.5 V for
N-American, and 1.0 V for European machines.
See "Detailed Section Descriptions - Exposure
Lamp Voltage Control" for details.
Forced Toner Forces the toner bottle to supply toner to the
Supply development unit.
This mode starts when the
63
and stops automatically after the selected time.
Use this mode to achieve standard image
density when copy quality problems indicate
low toner.
V Correction Sets the V
R
64
Value Keep this at the default setting.
TD Sensor Performs the TD sensor initial setting.
Initial Setting This SP mode controls the voltage applied to the TD
sensor to make the TD sensor output 1.9 ± 0.1 V.
After using SP66, check SP67 to see if the sensor is
66
working correctly.
This mode is started by pressing the
and stops automatically after about 1 minute.
Use this mode only after installing new
developer.
TD Sensor Display the TD sensor initial setting output.
67 Initial Output
Display
SM
CÓPIA NÃO CONTROLADA
Function
!
key to monitor the temperature
correction. The exposure
L
Exposure Lamp
0 +2 steps/8,000 copies
1 +2 steps/6,000 copies
2 +2 steps/4,000 copies
3 +2 steps/2,000 copies
4 +2 steps/1,000 copies
5 No Correction
!
correction value.
R
4-19
CÓPIA NÃO CONTROLADA
PROGRAM MODES
Settings
0 ~ 8
Default = 2
Note
Default
0: 6 seconds
1: 3 seconds
key is pressed,
Default = 0
key
(0.02 V x
displayed
value)
A219