Copy Adjustments: Printing/Scanning; Registration - Leading Edge/Side-To-Side - Ricoh D017 Service Manual

4.10 COPY ADJUSTMENTS: PRINTING/SCANNING

You must do these adjustment(s) after replacing any of the following parts:
Scanner Wire
Lens Block/SBU Assembly
Scanner Drive Motor
Polygon Mirror Motor
Paper Side Fence
Memory All Clear
For more details about accessing SP modes, see Service Tables.
4.10.1 PRINTING
Make sure the paper is installed correctly in each paper tray before you start these
adjustments.
Use the Trimming Area Pattern (SP2-902, No.10) to print the test pattern for the
following procedures.
Set SP 2-902 to 0 again after completing these printing adjustments.

Registration - Leading Edge/Side-to-Side

1. Check the leading edge registration for each paper feed station, and adjust them using
SP1-001.
2. Check the side-to-side registration for each paper feed station, and adjust them using
SP1-002.
Tray
Any paper tray
By-pass feed
Duplex
1st paper feed
2nd paper feed
D017/D018/D019/D020/D084/D085
SP mode Specification
SP1-001-1
SP1-001-2 3 ± 2 mm
SP1-001-3
SP1-002-1
SP1-002-2 2 ±1.5 mm
4-71
Copy Adjustments: Printing/Scanning
SM