Ricoh A219 Service Manual page 136

Mode No.
Image Bias Adjusts the development bias voltage used in
Adjustment manual ID mode. This adjustment affects all manual
(Manual ID ID settings. Use this SP mode to adjust the density
Mode) of pale gray areas.
SP Setting
33
See "Detailed Descriptions - Development" for more
details.
Image Density Selects the image density level in ADS mode.
Adjustment The development bias and the exposure lamp
(ADS Mode) voltages are increased or decreased.
This adjustment affects copies made in ADS mode.
SP Setting
34
The exposure lamp setting specifies the change
relative to the base exposure lamp voltage (Vo) in
SP48, 1 step of the lamp voltage equals 0.5 V for
120 V (NA), and 1.0 V for 230 V (EU) machines.
See "Detailed Descriptions - Development" for more
details.
Total Toner Selects the toner supply motor on time after every
Supply ON copy job during a toner near/end condition.
Time During
See "Detailed Descriptions - Toner Supply" for more
35
Toner
details.
Near/End
This SP mode is intended for designer use only.
Condition
SM
CÓPIA NÃO CONTROLADA
Function
Setting Dev. Bias
0 Normal 0
1 Darkest +40 V
2 Darker +20 V
3 Lighter –20 V
4 Lightest –40 V
Setting Dev. Bias
0 Normal 0
1 Lighter –40 V
2 Darker +40 V
3 Lightest –40 V
4 Darkest +40 V
4-15
CÓPIA NÃO CONTROLADA
PROGRAM MODES
Settings
0: Normal
1: Darker
2: Darkest
3: Lighter
4: Lightest
Note
Default
0: Normal
1: Light
2: Dark
3: Lighter
4: Darker
Exposure Lamp
0
0
0
+4 steps
–4 steps
1: 10 s
2: 20 s
3: 30 s
4: 40 s
5: 50 s
6: 60 s
A219