Feed Roller Replacement - Ricoh A219 Service Manual

REPLACEMENT AND ADJUSTMENT

9.4 FEED ROLLER REPLACEMENT

[G]
[F]
1. Turn off the main switch.
2. Remove the feed-in unit. (See Feed-in Unit Removal.)
3. Remove the feed roller timing belt [A], feed roller gear [B] (1 E-ring and 1
spring pin [C]) and 1 bushing [D].
NOTE: Be careful not to lose the spring pin.
4. Slide the feed roller shaft [E] towards the front and remove the feed clutch
[F] (1 E-ring and 1 connector).
5. Take out the feed roller shaft (1 spacer and 1 bushing ----- from the rear
side).
6. Remove the feed roller [G] from the shaft (3 idler rollers [H], 7 E-rings and
1 spring pin [I]).
NOTE: Be careful not to lose the spring pin.
A662
CÓPIA NÃO CONTROLADA
[H]
8-18
CÓPIA NÃO CONTROLADA
[E]
[I]
[C]
[A]
[D]
A662R505.img
[B]
SM