Table of Contents
Advertisement
Rev. 11/2000
[C]
[A]
A245I502.wmf
⇒
into the imaging unit. Then rotate the outer gear [G] for one or two turns
to distribute the developer as shown.
NOTE: When installing new developer or manually rotating the
development roller, always make sure to turn the gear in the
direction shown above. Also do not rotate the gear more than 3
turns to prevent damage to the unit.
⇒
10. Remount the cover on the imaging unit, and install the unit in the copier.
Push the unittoward the back until it stops. While holding the unit in this
position, tighten the knob screw by hand. For the final tightening, use a
screwdriver or coin as shown in the illustration above. Then turn the "B1"
lever counter-clockwise to raise the transfer corona unit.
SM
CÓPIA NÃO CONTROLADA
[B]
[G]
6. Turn the "B1" lever [A]
7. Remove the knob screw [B] and
8. Remove the cover [D] from the
9. Pour in the developer [F] evenly
11-17
CÓPIA NÃO CONTROLADA
[F]
[D]
counterclockwise to lower the
transfer corona unit.
gently pull out the imaging unit
[C].
Then place it on a clean sheet of
paper.
imaging unit (1 screw and 1 snap
[E]).
INSTALLATION
[E]
A245I503.wmf
A245
Advertisement
Table of Contents
