Roller Drive Belt Replacement - Ricoh A219 Service Manual

ROLLER DRIVE BELT REPLACEMENT

10. ROLLER DRIVE BELT REPLACEMENT
[K]
[L]
[I]
[M]
[N]
1. Remove the front cover [A] (1 screw).
2. Remove the rear cover [B] (1 screw) and the sorter hinge [C] (2 screws).
3. Remove the rear flat cover [D] (2 screws).
4. Lift off the top cover [E].
5. Lift the upper paper guide [F] up and out of position (1 grounding wire).
6. Remove the entrance guide bracket [G] (2 screws).
7. Lift the lower paper guide [H] out of position and turn it over to remove the
roller drive belt [I].
NOTE: Be careful not to damage the bin home position switch actuator
[J] when reassembling.
8. Remove the transfer spacer [K], wheel [L], pin [M], and bushing [N] on
both sides of the shaft.
9. Slide the wheel shaft towards the front and replace the roller drive belt.
A657
CÓPIA NÃO CONTROLADA
[F]
[H]
[D]
A657R502.img
9-10
CÓPIA NÃO CONTROLADA
[E]
[G]
A657R501.img
[C]
[B]
A657R503.wmf
SM
[A]