Table of Contents
Advertisement
15. Pull the paper tray [A] out and turn the paper size dial [B] to select the
appropriate size. Adjust the side guides [C] and the end guide [D] to
match the paper size.
NOTE: 1) Make sure the stack of paper is aligned, and that there is no
space between the side guides and the paper stack.
2) Always push the paper tray in gently.
16. Plug in the copier and turn on the main switch. Wait until it warms up. (It
takes about 45 seconds.)
17. Enter the SP mode as follows:
1) Press the "Clear Modes" key.
2) Enter "107" using the numeric keys.
3) Hold down the "Clear/Stop" key for more than 3 seconds.
18. Perform the TD sensor initial setting as follows:
1) Enter "66" using the numeric keys.
2) Press the "Auto Image Density" key.
NOTE: The machine will automatically stop when completed. (It takes
about 1 minute.)
19. Turn the main switch off and on to exit SP mode.
20. Check the copy quality and machine operation.
21. Inform the customer of the notes in step 13 concerning the paper tray.
Also find out if the customer changes paper sizes frequently. If not, inform
the customer that the side guides can be fixed with a screw [E] to achieve
better paper feed quality (use a tapping screw less than 8 mm long).
SM
CÓPIA NÃO CONTROLADA
[E]
[C]
[D]
11-19
CÓPIA NÃO CONTROLADA
INSTALLATION
[B]
[A]
[C]
A245I505.wmf
A245
Advertisement
Table of Contents
