Ricoh A219 Service Manual page 341

PROGRAM MODE
Mode No.
V Correction Sets the interval for V
L
Interval lamp voltage (SP48) is increased by 1 step at the
set copy count interval.
SP Setting
62
1 step of the lamp voltage equals 0.5 V for
N-American, and 1.0 V for European machines.
See "Detailed Section Descriptions - Exposure
Lamp Voltage Control" for details.
Forced Toner Forces the toner bottle to supply toner to the
Supply development unit.
This mode starts when the
63
and stops automatically after the selected time.
Use this mode to achieve standard image
density when copy quality problems indicate
low toner.
V Correction Sets the V
R
64
Value Keep this at the default setting.
TD Sensor Performs the TD sensor initial setting.
Initial Setting This SP mode controls the voltage applied to the TD
sensor to make the TD sensor output 1.9 ± 0.1 V.
After using SP66, check SP67 to see if the sensor is
66 working correctly.
This mode is started by pressing the
and stops automatically after about 1 minute.
Use this mode only after installing new
developer.
TD Sensor Display the TD sensor initial setting output.
67 Initial Output
Display
V Correction Selects or deselects V
L2
Selection
Keep this setting at 0.
68
A245
CÓPIA NÃO CONTROLADA
Function
correction. The exposure
L
Exposure Lamp
0 +2 steps/8,000 copies
1 +2 steps/6,000 copies
2 +2 steps/4,000 copies
3 +2 steps/2,000 copies
4 +2 steps/1,000 copies
5 No Correction
6 +2 steps/500 copies
7 +2 steps/200 copies
!
correction value.
R
correction.
L2
11-34
CÓPIA NÃO CONTROLADA
Settings
0 ~ 8
Default = 2
Note
Default
0: 6 seconds
1: 3 seconds
key is pressed,
Default = 0
key
(0.02 V x
displayed
value)
0: V
L2
Correction
1: No V
Correction
L2
SM