Ricoh A219 Service Manual page 106

Rev. 11/2000
[A]
A219I502.wmf
⇒
7. Pour in the developer [F] evenly into the imaging unit. Then rotate the
outer gear [G] for one or two turns to distribute the developer as shown.
NOTE: When installing new developer or manually rotating the
development roller, always make sure to turn the gear in the
direction shown above. Also do not rotate the gear more than 3
turns to prevent damage to the unit.
⇒
8. Remount the cover on the imaging unit, and install the unit in the copier.
Push the unit toward the back until it stops. While holding the unit in this
position, Tighten the knob screw by hand. For the final tightening, use a
screwdriver or coin as shown in the illustration above. Then turn the "B1"
lever clockwise to raise the transfer corona unit.
SM
CÓPIA NÃO CONTROLADA
[B]
[C]
4. Turn the "B1" lever [A]
counterclockwise to lower the
transfer corona unit.
5. Remove the knob screw [B] and
gently pull out the imaging unit [C].
Then place it on a clean sheet of
paper.
6. Remove the cover [D] from the
imaging unit (1 screw and 1 snap
[E]).
3-5
CÓPIA NÃO CONTROLADA
COPIER (A219)
[F]
[D]
A219I503.wmf
[G]
[E]
A219