Ricoh A219 Service Manual page 337

PROGRAM MODE
Mode No.
Image Density Selects the image density level in ADS mode.
Adjustment The development bias and the exposure lamp
(ADS Mode) † voltages are increased or decreased.
This adjustment affects copies made in ADS mode.
SP Setting
34
The exposure lamp setting specifies the change
relative to the base exposure lamp voltage (Vo) in
SP48, 1 step of the lamp voltage equals 0.5 V for
120 V (NA), and 1.0 V for 230 V (EU) machines.
See "Detailed Descriptions - Development" for more
details.
Total Toner Selects the toner supply motor on time after every
Supply ON copy job during a toner near/end condition.
Time During
See "Detailed Descriptions - Toner Supply" for more
35
Toner
details.
Near/End
This SP mode is intended for designer use only.
Condition
TD Sensor Adjust the sensitivity of the TD sensor.
Sensitivity Normally, this value should not be changed.
Setting
SP Setting
36
The toner supply motor on time and/or the toner
density are changed by this setting. See
"Detailed Descriptions - Toner Supply Control"
for more details.
A245
CÓPIA NÃO CONTROLADA
Function
Setting Dev. Bias
0 Normal 0
1 Lighter –40 V
2 Darker +40 V
3 Lightest –40 V
4 Darkest +40 V
Sensitivity (V/wt%)
0 0
1 0.05
2 0.10
↓
Å
12 0.60
13 0.65
14 0.70
15 0.75
16 0.80
↓
Å
19 0.95
20 1.00
11-30
CÓPIA NÃO CONTROLADA
0: Normal
1: Light
2: Dark
3: Lighter
4: Darker
Exposure Lamp
0
0
0
+4 steps
–4 steps
1: 10 s
2: 20 s
3: 30 s
4: 40 s
5: 50 s
6: 60 s
0 ~ 20
Default = 15
Note
0.05 per step
Default
0.05 per step
Settings
SM