Ricoh A219 Service Manual page 116

[E]
[C]
[D]
7. Install the sorter [A] on the sorter holder bracket [B] (1 snap ring) as
shown.
8. Insert the sorter harness [C] and the grounding wire [D] through the
opening in the lower left cover. Plug the connector in to CN130 [E] on the
main control board, and secure the grounding wire to the copier frame [F]
(1 M4 x 8 screw).
9. Secure the bracket [G] (1 tapping screw).
10. Reinstall the rear cover.
11. Plug in the copier power cord and turn on the main switch.
12. Enter SP mode as follows:
1) Press the # key.
2) Enter "107" using the numeric keys.
3) Hold down the $ key for more than 3 seconds.
13. Press the following sequence of keys to change the "SP 71" value to "1".
 
→ →
14. Turn the main switch off and on.
15. Check the sorter's operation.
SM
CÓPIA NÃO CONTROLADA
[B]
[F]
[G]

→ →
3-15
CÓPIA NÃO CONTROLADA
SORTER (A657)
[A]
A657I504.wmf
A219