Changing Network Protocols - NEC Xen IPK Installation Manual

Changing Network
Protocols
S 1
E C T I O N
C
HANGING NETWORK
PROTOCOLS
Xen IPK Xen Mail CTI Installation Guide
Chapter C – Changing Network Protocols

Changing network protocols

To change the network protocol configuration for an existing voice
messaging system, perform the following procedure.
To remove a network protocol configuration, perform the procedure, "To
remove the existing network protocol configuration" on page 94.
To change an existing network protocol configuration
1 Ask your network administrator for the information required to set up
network protocols. Refer to the table in Chapter 2 for details.
2 Shut down the voice messaging system application by pressing ESC at
the Banner screen and then following the system prompts.
3 At the OS/2 command prompt, type f: and press ENTER.
4 Type cd \ and press ENTER.
5 Type setup and press ENTER.
6 Type y to proceed with the voice messaging system Setup utility.
7 Press ENTER to continue until you reach the Setup Type menu.
8 From the Setup Type menu, type 2 to choose "Configure system" and
press ENTER.
9 Press ENTER to confirm that the voice messaging software is installed
on drive E.
10 Press ENTER to confirm that the voice messaging software is installed
in the Vmail directory.
11 Review the features and options available with your system that are
listed on-screen. Press ENTER to continue.
12 From the Update Configuration menu, type 3 to reconfigure network
protocols and press ENTER.
13 When you have completed your selection(s), press ENTER.
14 Follow the on-screen instructions to continue.
15 From the Setup Complete menu, type y and press ENTER to exit the
Setup utility.
16 Shut down and restart the voice messaging system by setting the
board's Shutdown switch Off. After the system has shut down, set the
switch On and then press the Power button to restart.
Appendix C
Appendix C - 93