NEC Xen IPK Installation Manual page 50
Hide thumbs
Also See for Xen IPK:
- Features & specifications manual (640 pages) ,
- Programming manual (638 pages) ,
- Manual (24 pages)
Table of Contents
Advertisement
June 2004
44 - Chapter 4
To install network protocols for backups, continued
1 At the OS/2 command prompt, type f: and press ENTER.
2 Type cd \ and press ENTER.
3 Type setup and press ENTER.
4 Type y to proceed with the voice messaging system Setup utility.
5 From the Setup Type menu, type 2 to choose "Configure System" and
press ENTER.
6 Follow the on-screen instructions until you reach the Update
Configuration menu.
7 Choose "Configure Network Protocols (for Network Backup/Restore)" by
typing the corresponding menu number and pressing ENTER.
8 When you have completed your selection, press ENTER to continue.
9 From the Select Network Protocols menu, select all that apply:
• To select IPX/SPX, type
• To select TCP/IP, type
• To select NetBIOS over TCP/IP, type
To set up NetBIOS over TCP/IP, a TCP/IP configuration is also
NOTE:
required. Select option 2 and 3 to set this up.
10 When you have completed your selection(s), press ENTER.
11 If you selected TCP/IP, perform the following actions. Otherwise, go to
step 13.
1
• Type
and press ENTER. Type the correct value for the "TCP/IP Address"
field and press ENTER.
• Type
2
and press ENTER. Type the correct value for the "Subnet Mask"
field and press ENTER.
• Type
3
and press ENTER. Type the correct value for the "Default Router"
field and press ENTER.
4
• Type
and press ENTER. Type the correct value for the "Domain" field and
press ENTER.
• Type
5
and press ENTER. Type the correct value for the "Name Server"
field and press ENTER.
12 Confirm your entries are correct. Press ENTER to continue.
13 If you selected IPX/SPX, perform the appropriate action below.
Otherwise, go to step 2.
• To select "Version 3.x or 4.x bindery mode," type
• To select "Version 4.x directory service," type
14 If you selected "Version 3.x or 4.x bindery mode," perform the following
actions. Otherwise, go to step 15.
• Type
m
and press ENTER. Type the correct value for the "NetWare name
context" field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.
NEC Business Solutions Ltd
1
and press ENTER.
2
and press ENTER.
3
and press ENTER.
2
Backing Up & Restoring the System
1
and press ENTER.
and press ENTER.
Advertisement
Table of Contents
