NEC Xen IPK Installation Manual page 25

Xen IPK Xen Mail CTI Installation Guide
Setting Up the System
8 Type y to proceed with the voice messaging system Setup utility.
9 From the Setup Type menu, type 2 to choose "Configure system" and
press ENTER.
10 Press ENTER to confirm that the voice messaging software is installed
on drive E.
11 Press ENTER to confirm that the voice messaging software is installed
in the Vmail directory.
12 Review the features and options available with your new system that are
listed on-screen. Press ENTER to continue.
13 From the Update Configuration menu, choose all the configuration
options you want to set up your system:
• To set up TeLANophy, type 1 and press ENTER.
• To enable network backups, type 3 and press ENTER.
• To select the system language, type 4 and press ENTER.
NOTE: Numbers for each menu item may vary.
14 When you have completed your selection(s), press ENTER.
To set up the voice messaging system software, continued
1 From the Select Network Protocols menu, select all that apply:
• To select IPX/SPX, type 1 and press ENTER.
• To select TCP/IP, type 2 and press ENTER.
• To select NetBIOS over TCP/IP, type 3 and press ENTER.
NOTES:
• Either a TCP/IP or IPX/SPX configuration is required for TeLANophy.
• Either an IPX/SPX or a NetBIOS over TCP/IP configuration is required to
perform network backups.
• To set up NetBIOS over TCP/IP, a TCP/IP configuration is also required.
Select option 2 and 3 to set this up.
2 When you have completed your selection(s), press ENTER.
3 If you selected TCP/IP, perform the following actions. Otherwise, go to
step 5.
• Type 1 and press ENTER. Type the correct value for the "TCP/IP Address"
field and press ENTER.
• Type 2 and press ENTER. Type the correct value for the "Subnet Mask" field
and press ENTER.
• Type 3 and press ENTER. Type the correct value for the "Default Router"
field and press ENTER.
• Type 4 and press ENTER. Type the correct value for the "Domain" field and
press ENTER.
• Type 5 and press ENTER. Type the correct value for the "Name Server" field
and press ENTER.
4 Confirm your entries are correct. Press ENTER to continue.
Chapter 2 - 19