NEC Xen IPK Installation Manual page 96

June 2004
Designation
iCMC System
Diagnostic
OP-STA1
OP-STA2
ENET CON.
ENET BSY.
APPL.
H.D.
Shutdown
LAN
COM-1
COM-2
90 - Appendix A
Control
Red LED Indicator
Yellow LED Indicator
Red LED Indicator
Green LED Indicator
Yellow LED Indicator
Red LED Indicator
Green LED Indicator
Push button
Connector, 8 pin
modular socket ISO
8877
Connector, D-type
RS-232 9 Pin
Connector, D-type
RS-232 9 pin
Purpose
After the board is installed, this LED lights to indicate
initialisation and then turns off after the board is
completely initialised, (after a few seconds).
• Remains On over 5 minutes — indicates initialisation
failure
• Off — indicates normal operation
• Flashing — indicates hardware failure
Displays computer status 1
Displays computer status 2
Ethernet Connection indicator
Ethernet Busy indicator
AV Application status
Hard Drive R/W activity
Push to shutdown and restart the board
10 Base-T LAN Connector, TCIP/IP socket service;
Ethernet Port
Serial #1 provide EIA/TIA RS-232C compatibility, wired
as DTE; modem or PMS port
Serial #2 provide EIA/TIA RS-232C compatibility, wired
as DTE; default console port for direct connections
NEC Business Solutions Ltd
About the System Board