NEC Xen IPK Installation Manual page 19

Xen IPK Xen Mail CTI Installation Guide
Setting Up the System
To set up trunk routing
Memory block 3-42 assigns direct inward termination (DIT) of central office
(CO) lines during day mode for the system. Memory block 3-43 directs CO
lines during night mode. Perform this procedure if you are planning to use
the voice messaging system's automated attendant.
1 Press the LK3 key.
2 Press the TRANSFER key.
3 Dial 42.
4 Press * four times, then enter the number of the first CO line to ring the
voice messaging system.
5 Enter the extension of a voice messaging system hunt group master
port.
6 Press the TRANSFER key to save the CO line assignment for day mode
and to advance to the next memory block.
7 Enter the extension of a voice messaging system hunt group master
port
8 Press the TRANSFER key again to save the CO line assignment for
night mode.
9 Press * .
10 Dial 2.
11 Press the CONF key to advance to the next CO line.
12 Repeat steps 5 through 11 for each CO line to ring the voice messaging
system.
13 Press the ANSWER key to exit the DIT assignment.
To make the forward all calls setting available by class of service
Memory block 1-8-08 enables the selected class of service to forward all
calls.
1 Press the LK1 key.
2 Press the LK8 key.
3 Dial 08.
4 Enter the class of service number.
5 The LK1 key is lit when the forward all calls setting is available to the
selected class of service. Press the LK1 key if it is not already lit.
6 Press the TRANSFER key to save the selection and advance to the next
class of service.
7 Repeat steps 4 through 5 for each class of service that requires the
forward-all-calls setting.
8 Press the ANSWER key twice to exit the forward-all-calls selection.
Chapter 2 - 13