Adding Feature Packages; Steps For Adding Feature Packages - NEC Xen IPK Installation Manual

June 2004
S 4
E C T I O N
A
DDING FEATURE
PACKAGES
66 - Chapter 5
To add feature packages, such as TeLANophy or ActiveFax, perform the
following steps.

Steps for adding feature packages

1 Ask your network administrator for the information required to set up the
feature packages and network protocols at your site.
Some feature packages require a LAN integration. If the correct network
protocols are not set up on your system, you are prompted to set them up
when you configure the voice messaging system software. Refer to the
table below for details.
2 Configure voice messaging system software to use feature packages.
See "To add feature packages" on page 67.
3 If you added TeLANophy, set it up.
See TeLANophy overview, Chapter 6.
4 If you added ActiveFax, set it up.
See System Management Guide: FaxMail setup, Chapter 9.
5 Back up the voice messaging system.
See "Using the backup and restore utilities" on page 41.
Setup option Action required
Configure TCP/IP or IPX/SPX protocols
TeLANophy
For TCP/IP, indicate: subnet mask, router, domain, server name,
Network protocols
and TCP/IP address of voice messaging system
For IPX/SPX, indicate: NetWare bindery or directory mode, pre-
ferred server and name context, frame header type
For NetBIOS over TCP/IP, configure TCP/IP and indicate: NT
domain, NT user ID, and NT password
NEC Business Solutions Ltd
Upgrading the Voice Messaging System