NEC Xen IPK Installation Manual page 26

June 2004
20 - Chapter 2
5 If you selected IPX/SPX, perform the appropriate action below.
Otherwise, go to step 5.
• To select "Version 3.x or 4.x bindery mode," type 1 and press ENTER.
• To select "Version 4.x directory service," type 2 and press ENTER.
To set up the voice messaging system software, continued
1 If you selected "Version 3.x or 4.x bindery mode," perform the following
actions. Otherwise, go to step 2.
• Type m and press ENTER. Type the correct value for the "NetWare name
context" field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.
2 If you selected "Version 4.x directory service," perform the following
actions:
• Type m and press ENTER. Type the correct value for the "NetWare name
context" field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.
• Type m and press ENTER. Type the correct value for the "Preferred NetWare
server name" field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.
3 From the Ethernet Frame Header menu, perform the appropriate action
below:
• To select "Ethernet 802.2," type 1 and press ENTER.
• To select "Ethernet 802.3," type 2 and press ENTER.
• To select "Ethernet Snap," type 3 and press ENTER.
• To select "Ethernet II," type 4 and press ENTER.
4 When you have completed your selection, press ENTER to continue.
5 If you selected NetBIOS over TCP/IP, perform the following actions.
Otherwise, go to step 1.
• Type 1 and press ENTER. Type the correct value for the "Workstation name"
field and press ENTER.
• Type 2 and press ENTER. Type the correct value for the "NT Domain name"
field and press ENTER.
• Type 3 and press ENTER. Type the correct value for the "Workstation
description" field and press ENTER.
NOTE: If you have not configured TCP/IP, an error message is displayed. Fol-
low the on-screen instructions to continue.
6 Press ENTER to confirm your entries.
NEC Business Solutions Ltd
Setting Up the System