Right-Side Components - Arctic Cat 300 Utility Service Manual

4. Place the fixed drive face into position on the crank-
shaft and engage the splines making sure the splines
extend beyond the pulley face hub.
5. On the Utility, install the starter ratchet on the crank-
shaft making sure to engage the splines; then secure
with the flange nut and tighten to 68 ft-lb.
6. Install the centrifugal clutch housing and clutch collar;
then secure with the flange nut and tighten to 40 ft-lb.
KM369
KM263A 7. Install the alignment pins and a new gasket on the
crankcase; then install the V-belt cover and secure
with the cap screws. Tighten securely.
8. On the Utility, install the recoil starter and secure
with the cap screws. Tighten securely.

Right-Side Components

 AT THIS POINT
To service center crankcase components only, proceed
to Removing Right-Side Components.

NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
KM366
technician should use discretion and sound judgment.
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.

NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
KM365
AT THIS POINT

KM253
KM368
51