Servicing Right-Side Components - Arctic Cat 300 Utility Service Manual

Arctic cat atv 2014 service manual
Hide thumbs Also See for 300 Utility:
Table of Contents

Advertisement

NOTE: The starter one-way clutch bearing is direc-
tion oriented and will only function if installed prop-
erly. Note the markings or arrows when removed.
AT THIS POINT

To service the stator coil, see Electrical System.
AT THIS POINT

To service the trigger coil, see Electrical System.
F. Oil Pump
NOTE: Steps 14-18 in the preceding sub-section
must precede this procedure.
19. Remove the rotor/flywheel (see Rotor/Flywheel in
this sub-section).
20. Remove the starter drive gear and place together
with the rotor/flywheel to keep the one-way clutch
bearing intact.
KM775
21. Remove the two cap screws securing the oil baffle to
the crankcase and remove the baffle; then remove the
snap ring securing the oil pump driven sprocket.
KM766A
22. Remove the oil pump drive chain and oil pump
driven sprocket.
23. Remove the two cap screws securing the oil pump to
the crankcase and remove the oil pump.
Servicing Right-Side
TRANSMISSION (DVX)
Inspecting
1. Measure the shift fork guide shaft runout. If runout
exceeds 0.03 mm, the shaft must be replaced.
KM767A
Components
KM766A
KM428
KM429
57

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvx 300300 utility 2014Dvx 300 2014

Table of Contents