Right-Side Components - Arctic Cat 2012 DVX 90 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
7. Place the V-belt over the driven pulley; then over the
bushing/spacer. Pinch the belt in the middle to draw
it down into the driven pulley approximately 1 inch.
8. Install the fixed drive face onto the crankshaft and make
sure sufficient splines are protruding to allow the kick-
start ratchet to slide onto the splines; then install the
ratchet (B) and secure with the flange nut (A) coated
with red Loctite #271. Tighten to 27.5 ft-lb.
www.mymowerparts.com
YT164
Failure to fully engage the splines with the kick-start
ratchet could cause false torque reading and crankshaft
damage.
9. Install two alignment pins and the gasket; then
secure the V-belt cover to the crankcase and tighten
the cap screws in a crisscross pattern to 7 ft-lb. Make
sure the different-lengthed cap screw is located as
illustrated.
YT157

Right-Side Components

YT163A
To service center crankcase components only, proceed
to Removing Right-Side Components.
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Manual
Table of Contents
CAUTION
AT THIS POINT

AT THIS POINT

YT160B
YT099A
31