Right-Side Components; Removing Right-Side Components - Arctic Cat 2016 90 Utility Service Manual

YT157
YT163A
8. Install the fixed drive face onto the crankshaft and make
sure sufficient splines are protruding to allow the kick-
start ratchet to slide onto the splines; then install the
ratchet (B) and secure with the flange nut (A) coated
with red Loctite #271. Tighten to 27.5 ft-lb.
YT160B
CAUTION
Failure to fully engage the splines with the kick-start
ratchet could cause false torque reading and crankshaft
damage.
9. Install two alignment pins and the gasket; then
secure the V-belt cover to the crankcase and tighten
the cap screws in a crisscross pattern to 7 ft-lb. Make
sure the different-lengthed cap screw is located as
illustrated.
40
YT099A

Right-Side Components

AT THIS POINT

To service center crankcase components only, proceed
to Removing Right-Side Components.
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not have to be

removed from the frame for this procedure.
Removing Right-Side
Components
A. COOLING FAN
B. ROTOR/FLYWHEEL
C. STATOR COIL
D. OIL PUMP
1. Remove the intake pipe/carburetor. Account for an
O-ring in the intake pipe.
2. Remove the cooling fan shroud; then remove the
cooling shroud from the cylinder and cylinder head.
YT091A