Installing Left-Side Components - Arctic Cat 300 Utility Service Manual

4. Install the spring seat over the hub and movable face
hub.
5. Place the spring holder on the spring; then install the
spring on the pulley assembly.
6. Place the centrifugal clutch assembly, drive plate nut,
and clutch compressor adapter in position; then using
the clutch compressor wing nut, compress the clutch
spring and install the nut (lightly coated with red
Loctite #271).
50
KM384
7. Using a suitable holding fixture, tighten the drive
plate nut (coated with red Loctite #271) to 43 ft-lb.
Installing Left-Side
Components
A. Drive Pulley
B. Driven Pulley/Centrifugal Clutch
Assembly
C. V-Belt Cover
1. Install the movable drive face and drive pulley collar
on the crankshaft.
KM385
2. Open the faces of the driven pulley; then insert a
suitable wedge between the faces to hold them apart.
3. Place the V-belt around the pulley and push the belt
down between the pulley faces; then install the
driven pulley/centrifugal clutch assembly onto the
driveshaft. Loop the V-belt over the drive pulley col-
lar.
KM386
KM373
KM262