Steering Post Cover/Instrument Pod - Arctic Cat 300 Utility Service Manual

2. Using the existing hardware, secure the front fenders
to the fender supports; then connect the headlight.
3. Using the existing hardware, secure the rear fenders
to the forward fender supports; then secure the rear
fender to the frame with four cap screws and flange
nuts. Tighten securely.
4. Install the six cap screws securing the body to the top
of the frame. Tighten securely.
5. Install the fuse block, start-in-gear relay, and the
CDI; then install the body mounting cap screw into
the bottom of the battery box.
6. Install the battery and battery hold-down strap; then
connect the positive battery cable and the negative
battery cable.

NOTE: Always install the positive cable first; then
install the negative cable.
7. Install the seat making sure it is latched securely.
INSTALLING (Utility)
1. Place the front and rear fenders into position on the
frame and secure with the existing hardware; then
install the gas tank cover. Tighten all fasteners
securely.
2. Connect the headlight and taillight connectors; then
install the shift knob.
3. Making sure the locating tabs engage the appropriate
slots in the fenders, install the side panels.
4. Install the mud guards and secure to the fenders and
foot rest supports with the existing hardware. Make
sure all locating tabs are appropriately engaged with
the fenders and side panels.
22
5. Install the front center cover; then install the front
and rear racks. Tighten all fasteners securely.
6. Install the battery; then connect the positive battery
cable, negative battery cable, and battery hold-down
strap.

NOTE: Always install the positive cable first; then
install the negative cable.
7. Install the battery cover; then install the seat making
sure it locks securely in place.
Steering Post Cover/
Instrument Pod
REMOVING (DVX)
1. Remove the two reinstallable rivets on the rear of the
steering post cover; then lift up and push the assem-
bly forward to remove.
2. Disconnect the wire connectors from the indicator
lights and from the ignition switch.
REMOVING (Utility)
1. Remove the reinstallable rivet on the front of the
instrument pod and the two cap screws on the rear;
then lift the assembly off and disconnect the speed-
ometer cable.
KM340A
2. Remove the self-tapping screw securing the LCD
gauge assembly to the instrument pod; then remove
the LCD gauge.

NOTE: The LCD gauge is not a serviceable compo-
nent. If any functions are incorrect or indicator lights
do not illuminate, the LCD gauge must be replaced.
INSPECTING/SERVICING (DVX)
1. Remove the two self-tapping screws securing the
indicator lamp assembly in the steering post cover.
2. Inspect the bulbs for blackening or burn out. Replace
as required.
3. Inspect the indicator lamp holder for loose sockets, bro-
ken wires, or loose connections. Replace as required.
KM789A
KM788A