Fuel/Lubrication/Cooling; Carburetor - Arctic Cat 300 Utility Service Manual

Fuel/Lubrication/Cooling

Carburetor

KEY
1. Screw 13. O-Ring
2. Top 14. Cable
3. Spring 15. Tube
4. Seat, Spring 16. Pilot Screw
5. Jet Needle 17. O-Ring
6. Vacuum Piston 18. Float Arm Pin
7. Needle Jet 19. Float
8. Needle Jet Holder 20. O-Ring
9. Main Jet 21. Slow Jet
10. Starter Valve 22. Drain Screw
11. Coil Spring 23. Float Valve
12. Cap 24. Float Valve Clip
! WARNING
Whenever any maintenance or inspection is performed
on the fuel system during which there may be fuel leak-
age, there should be no welding, smoking, open flames,
etc., in the area.
REMOVING
1. Remove the seat; then remove the gas tank (see Gas
Tank in this section).
2. Remove the cap screws securing the air filter hous-
ing to the frame; then loosen the clamp securing air
inlet boot to the carburetor and remove the air filter.
3. Remove the choke assembly from the carburetor
.
4. Remove the screw securing the throttle actuator
25. Float Chamber
26. Screw
27. Clip
28. Drain Tube
29. Spring
30. Washer
31. Washer
32. Spring
33. Idle Adjust Screw
34. Top Cover
35. Screw
5. Remove the throttle cable from the actuator arm.
36. Starter Jet
0742-556
6. Loosen the outer jam nut securing the throttle cable
KM320A
leaving the choke cable attached to the choke
plunger.
cover to the carburetor; then remove the cover.
to the carburetor body; then route the cable out of the
way.
KC0018
PR154B
PR162C
73