Arctic Cat 300 Utility Service Manual page 37

14. Loosen the output drive boot clamp; then slide the
boot off the output housing.
15. Disconnect the shift linkage from the transmission
shift arm; then swing the shift linkage forward and
out of the way.
34
16. Remove the front engine through-bolt; then remove
the two engine mounting brackets from the frame.
KM360A
17. Attach a suitable lifting sling and engine lift to the
front engine mounting boss; then using an engine
lift, apply slight upward pressure on the engine/
transmission.
KM323
18. Remove the upper rear and lower rear engine
through-bolts to free the engine/transmission; then
raise the front of the engine/transmission sufficiently
to allow the engine assembly to be moved forward
enough to disengage the driveshaft.
KM314
KM315A
KM414A
KM332A
KM333A