Arctic Cat 300 Utility Service Manual page 65

4. Install the flat thrust washer and driven bevel gear on
the driven shaft; then using the universal joint and
vise to hold the shaft, install a new nut and tighten to
72 ft-lb.
5. Use a center punch to stake the nut to the driven
shaft.
6. Install the high drive gear thrust washer on the coun-
tershaft; then install the high drive gear and secure
with a circlip.
7. Install the high gear clutch dog and flat washer. At
this point, the countershaft is ready for installation.
62
8. Install the low driven gear washer on the driveshaft;
then install the low driven gear and thrust washer.
Secure with a snap ring.
KM425
9. Install the low/reverse clutch dog and spacer washer;
then install the reverse gear and reverse gear thrust
washer. At this point, the driveshaft is ready for
KM426A
installation.
10. Apply clean engine oil to the assembled shafts and
gears; then install the countershaft and driveshaft
KM685A
simultaneously into the transmission case.
KM684
KM692A
KM690A