Arctic Cat 300 Utility Service Manual page 35

18. Remove the front engine mounting through-bolt;
then remove the left and right engine mounting
brackets from the frame.
19. Attach a suitable lifting sling and engine lift to the
front engine mounting boss.
20. Raise the engine lift to take the slack out of the sling;
then remove the upper rear and lower rear engine
through-bolts.
21. Raise the front of the engine sufficiently to allow the
engine assembly to be moved forward enough to clear
the rear mounting brackets (approximately 6 in.).
22. Lower the front of the engine slowly, swing the rear
of the engine to the left, and slide the engine out of
the left-side of the frame.
32
KM332
Utility
1. Remove the seat; then remove the battery box cover.
KM333A
2. Remove the negative cable from the battery; then
remove the positive cable.
3. Drain the coolant, engine oil, and transmission gear
lubricant; then install the drain plugs and tighten to
21 ft-lb.
KM325A
KM330
KM331
KM133A