Servicing Left-Side Components - Arctic Cat 300 Utility Service Manual

B. V-Belt Cover
C. Drive Pulley
D. Driven Pulley/Centrifugal Clutch
Assembly

NOTE: On the Utility, step 1 in the preceding sub-
section must precede this procedure.
2. Remove the ten cap screws securing the V-belt
cover; then remove the cover noting the location of
the two dowel pins. Note the condition of the V-belt
cover gasket. Replace if damaged.
3. On the Utility using a suitable holder to prevent the
drive pulley from turning, remove the drive face nut
and starter ratchet; then remove the drive pulley face.
4. Hold the centrifugal clutch with a suitable holder;
then remove the clutch retaining nut and clutch collar.
5. Remove the outer clutch housing; then remove the
centrifugal clutch, driven pulley, and V-belt.
44
6. Remove the drive pulley collar and the movable
drive face taking care not to loose the rollers.
Servicing Left-Side
Components
RECOIL STARTER (Utility)
KM253
Always wear safety glasses when servicing the recoil
starter.
Removing/Disassembling
1. Remove the cap screws securing the recoil starter
assembly to the V-belt cover; then remove the starter.
Account for two alignment pins.
KM365
During the disassembling procedure, continuous back-
ward pressure must be exerted on the reel so it does
not accidentally unwind and cause injury.
2. Rotate the reel clockwise until the notch of the reel is
near the rope guide in the case. Guide the rope into
the notch and slowly allow the reel to unwind until
all spiral spring tension is released.
During the disassembling procedure, make sure all
KM364
spring tension is released before continuing.
3. Remove the cap screw. Account for the ratchet
guide, spacer, and spring.
! WARNING
! WARNING
CAUTION
KM369
KM413A