Left-Side Components; Removing Left-Side Components - Arctic Cat 300 Utility Service Manual

11. Install the cam chain tensioner cover bolt and tighten
to 24 in.-lb.
12. Check that the cam gear alignment marks are cor-
rectly oriented; then install and tighten the external
cylinder head to cylinder cap screws to 7 ft-lb.
13. Install the cylinder head cover with a new O-ring and
tighten securely.
14. Install the air pipe and vent hose using the existing
cap screws and clamp.
KM705
15. Install the air hose into the cylinder head.

Left-Side Components


NOTE: For efficiency, it is preferable to remove and
KM703
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.

NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Left-Side
KM937A
A. Recoil Starter (Utility)
1. Remove the five recoil starter cover cap screws.
Remove the recoil starter assembly noting the loca-
tion of the dowel pins. Note the condition of the
recoil cover gasket. Replace if damaged.
To service the recoil starter, see Servicing Left-Side
Components sub-section.
AT THIS POINT

Components
AT THIS POINT

KM938A
KM941A
43